Patterns

From the Enhance section in the toolbox, select the the Pattern Stamp tool. (If you don’t see it in the toolbox, select the Clone Stamp tool , and then click the Pattern Stamp tool icon in the Tool Options bar.)

Choose a pattern from the Pattern pop-up panel in the Tool Options bar. To load additional pattern libraries, select a library name from the panel menu, or choose Load Patterns and navigate to the folder where the library is stored. You can also define your own pattern.

Set Pattern Stamp tool options in the Tool Options bar, as desired, and then drag within the image to paint.

You can specify any of the following Pattern Stamp tool options:

Sets the brush tip. Click the arrow next to the brush sample, choose a brush category from the Brush drop-down, and then select a brush thumbnail.

Paints the pattern using paint daubs to create an impressionist effect.

Sets the size of the brush in pixels. Drag the Size slider or enter a size in the text box.

Sets the opacity of the pattern you apply. A low opacity setting allows pixels under a pattern stroke to show through. Drag the slider or enter an opacity value.

Specifies how the paint that you apply blends with the existing pixels in the image. (See About blending modes.)

Repeats the pattern as a contiguous, uniform design. The pattern is aligned from one paint stroke to the next. If Aligned is deselected, the pattern is centered on the pointer each time you stop and resume painting.

Do one of the following:

• To create a pattern from part of the image, make a rectangular selection with Feather set to 0 pixels.

• To create a pattern from the entire image, deselect everything.

Choose Edit > Define Pattern From Selection.

Enter a name for the pattern in the Pattern Name dialog box.

To deselect the original selection, choose Select > Deselect.